My Profile

Keep Up to Date:
Blog RSS
Blog
Forum RSS
Forum

yamaha

Just purchased two '95 701 waveraiders. Is there any need to be concerned about the oil pump on this yamaha model failing? If so what can be done?
Hi all, does anyone have any comments good or bad about the xlt1200? or any recommendations for a 3 seater, uses - fun, towing wake board etc. My budget probably wont extend to the 4 stroke range of
I'm looking a two pair of ski's. The first is a 2000 Yamaha 1200 and a 2001 Yamaha GP1200R. The other is a 2000 Seadoo GTX and a 2001 Seadoo RX. both pairs have about 48 hrs on them. I'm looking for a
I swappend the battery for one from my other ski. I checked the fuse. NO gauge response...appears electrical ANY ideas ....what's the next easiest thing to check?
I picked up the '97 Wave Raider today. The dealer I got it from sells Kawasakis but not Yamaha's. They suggested I go to a Yamaha dealer and get some marine oil for the Wave Raider and also order a Us
...d this allready but i didnt see it ? anyway anybody have one of these ? cash or trade ? i have some yamaha stuff ( gp1200 ) , cyl,cdi gp 1200,ra1100 cdi ( protec ), 1100 cyl w/ pistons , rings (...
i have 2 yamaha 2007 vx cruisers for sale matching black, silver and red in color with 45 hours, sits 3 people, with reverse. if anyone is interested please let me know i'm in yuma, az. [IMAGE]
The fuel indicator (electronic) on my 97 GP1200 isn't working. It says I'm low even when the tank is full. Which of course keeps setting off the irritating warning beep. Any clues how to fix, or must
Region 1 Promoter Everclear Promotions does not have a Sport open class for the Yamaha waveblasters and Seadoo HX model boats, I have contacted Aaron Boatman and requested that he run this class he sa
Need throttle lever for Mikuni carb (fits Yamaha 701). Please email
02 Aquatrax F-12, 56 hours, excellent condition. 96 1100 Raider, 110 hours, fast, excellent condtion. Eagle custom trailer with stainless steel storage box and spare. Very nice. I'm the second owner o
...ff season and always covered. High hours (290) because I ride everyday but it also has a year and half of Yamaha factory warranty left with no limit on hours! Includes nice single trailer with about 2...
Need the last piece (end of the exhaust chamber) for a 701 62t engine. Please price and condition
...bulkhead. Do you have to remove the intake duct to pull this (which means removing the impeller etc)? RivaYamaha's exploded view doesn't indicate this....... Any advice how to replace the bearings ?...
Well my 1996 Yamaha 760 Wave raider has a problem..it wont shut off when i use the kill switch..i got a new one and it still is the same...does any one have any ideas on what could cause this? Confu
...ems. Now my question is, does a Kawasaki have to be flipped back over in a certain direction? We have two Yamaha's for Mom and I and the owner's manual shows that they have to be turned back over in a...
I have a '96 Yamaha Waveblaster II with a 760 in it. I was wondering if any has a service manual in PDF or any format or at least know how to test the CDI. I live in San Diego California and so far al
Does anyone make handgrip extensions for Yamaha XLT 1200's? My 7-year-old daughter and I have been riding for over three years and her hand size is getting to the point where I don't have enough grip
how do these work? http://www.parkeryamaha.com/index.asp?PageAction=VIEWPROD&ProdID=27088 I replaced the bearing in the driveshaft seal and bought a new one of these because I broke the rubber grease
...s it typically cost to replace an engine? Any recommendations in terms of who makes a good pwc? Kawasaki? Yamaha? Thanks for any advice!!...
...ch Brand new. Any other OEM parts you need -pipe, brackets, sponsons, just ask. I should have it. Other Yamaha parts are either off a 95 superjet or a 94 Blaster. -OEM dual 38 carbs with RIVA stacks...
...d be worth putting on to protect the bottom....Will it work? Any inputs will be appreciated. Randy... Yamaha 2001 XLT1200...
je recherche livret technique pour Yamaha wave runner XL 760 de 1999.
Can anyone recommend a competent, honest PWC mechanic in the Houston, TX area? My experience with Yamaha dealers has been less than satisfactory. Thanks.
...ject, and Ive just tore the motor down and the same thing, the front covers all rusty. Ive worked on many yamahas before, just never standups, and the flywheel compartment always looks pristine. Is it...
My Yam. 1100 bogges down when off idle, I took it to the shop, they said the carbs had a problem and their was a factory fix for the problem. They got a kit and rebuilt them. It ran fine for one seaso
...se so that the unit can be towed at speeds between 20 and 25 KTs? I have a jet Dingy (Nautica) that had a yamaha 760 Jet engine for power. Thanks...
... it just me or is eBay UK full of fraudulent jetskis? there are a few on there now (2x GSX LTD's, and a Yamaha WaveRunner 2001). Prices are too low, user id's have just been created, location is non...
I am looking at a 97' Yamaha Wave Raider 700cc. This will be my first PWC. Looking back in the archives, it seems that this Yamaha does not have the most power and there were complaints about the hull
...p land, I have a problem and wondered if anyone could help: Near the end of the season (2001), my '98 Yamaha XL1200 Waverunner with 120 hours began stalling or hesitating under the following speci...
Hi Folks - My poor Yamaha GP1200R has been sitting in the garage for 2.5 years... I know I know - a crime, but we bought a boat and the poor thing was neglected. However - I'm dying to get back in t
...ns and a 4 stroke test on page 64 june 2002. It puts the noise of the Honda at 83 db and the Doo at 78 db Yamaha 79 db. Top speed of the Honda Turbo is 57.9 the Doo is at 55.9 and Yamaha at 55.2 This ...
I have a Protec B-Body pipe for sale make an offer I am in VA, either email or respond to newsgroup!
Anyone know of any good mods for this ski? I would like to have a little more takeoff power. I have a 2000 XL800. Any info would be greatly
...95 D&T Sale $150.95 Seadoo XP Retail $169.95 D&T Sale $135.95 Polaris All Retail $189.95 D&T Sale $150.95 Yamaha GP Retail $169.95 D&T Sale $135.95 Yamaha SJ Retail $74.95 D&T Sale $60.95 Kawaski Ultr...
I just purchased a 1995 Yamaha waveraider 701 today for $2200.00. The guy i got it from was the first owner. I hope this was a good deal...this is my first ski. It is immaculate and the motor looks li
Does anyone know of a good Yamaha technician/tuner in the Annapolis, MD area? Thanks
does anyone know of a website that has a good parts breakdown and part numbers for yamaha GP800
Anyone know a place to get Yamaha replacement hoses cheaper than the dealer? They want $75 for the molded cooling line hose to the engine. A spare throttle or steering cable for my '97 Wave Venture co
The mod pipe works just as good as the limited on the 96 Blaster with the mods you mentioned. But, only the 96. The 96 has the raider cased motor that pulls more air than the older 93-95 model year bl
i need two sets of carbs for stock yamaha wave venture 1100 what ya got?
...so-called 'shop' bored this too-tight. Piston kit was from Wiseco. Also, I just got cylinders bored for a Yamaha 701 - Wiseco again. Since I now wonder about this guy, I measured clearances - about.00...
I'm looking for a used Factory limited pipe for a 95 Yamaha SJ. Anyone? Bueller? Bueller? Thanks in advance.
...ent know how and facts. Is the Keelshield plastic protector a good idea on a the bottom of a PWC? I heard Yamaha doesn't recommend them but maybe old that is old data. Any magazime tests I could read?...
Hi I need a Jet Ski Lock, Fits over Start/Stop Switch, with PAdLock It previously was in a Yamaha Accessories Catalog. It is Stainless Stell, fits over Start / Stop switch is when a padlock is u
hi what options do i have for a thinner spacer behind the prop on a 99 gp 12?
I just bought a 98 XL 1200. It had a new engine put in by an authorized Yamaha dealer in Nov 2000. The cover on the engine and the owners manual calls for BR8HS plugs gapped at .024. I just pulled the
Okay, I finally cleaned out my garage and I need to get rid of these parts I have. Here is what I have. If your interested in anything, e- 701 61X cylinder with stock pistons. Top end has only 5 hou
This ski is bone stock never raced. I am new to yamaha. All kawi,s have cooling line on hull to let you know water is going through. This ski does not. I was going to install a 3/8ths tee on hose goin
Anyone have any opinions on a 1998 Yamaha GP 800. My local dealer has a used one for sale $4000. I think it is priced a little high. What would be a fair price?? Any comments good or bad on this model
Page: 12

Copyright © 2006 - Nov 2008 My Jetski Buddies