water
I wonder why Polaris stopped using the T-stat in the new models? George can better answer the cold water restrictor jet in the cooling line trick for cold water riding. From what I have learned, you n...
i need a water injection solenoid to use with a microtouch dual controler on a factorypipe spec 2.and i needthe best water routing to use with this setup. thanks
jim
Which works better, a Stock reworked Sea-Doo waterbox for a 785 superstock or the Tony Doukas Racing waterbox. Anybody used one of his rebuilt crankshaft for a Sea-doo 785 superstock? Eric
...d,then what he has is just oil coming out of system.Allso when storing motor like that after flush (salt water)you can run motor 15 -20 sec. with out cooling water that help get water out of system wh...
it needs to be turned a certain way over if its upside down so the water will flow out of it if any has accumulated in the engine department. Otherwise if you start it and it has too much water in the...
Those motors are already prone to water injestion. You might try water injection though. I hear it works better. =)
jetski took on alot of water pulled plugs it is pumping water out of 2 of the 3 cylinders will it dry out or am i looking at the shop and a big expense?
...own there on the Llano.... Got there friday morning. It took us three hours to go 1.6 miles from the low water crossing to eagle rock.. i bashed up my skid plates, differentials, and gas tank. oh yeah...
...just bought my first Ski, a 2004 Polaris MSX150.
How do you flush a Ski and should you always connect a water hose when starting the engine out of water ??
Regards Eric...
...
Yep, I even have a used one for sale if you're interested. It's a very good grate for most water conditions.
The JD grate doesn't overstuff the pump on flat water like the most ...
...he diaphram, it is the piece below the diaphram. It keeps poping out of it's seat, shutting off all water to the chamber of the pipe. Either hard jet it or replace the water regulator.
Lazslo...
The water seperator has a red ring in it. If it is floating at the top then you have water in the tank, lines and seperator? If the ring is on the bottom then it's all gas? Also,you are talking C...
I like the 'Hot water prime trick' that's one I hadn't come across yet !
Also noteworthy is that some wetsuits are now made of a material that lets the water seep through from ...
...when they get to the ramp to prepare their machine, and what I should do right after I get it out of the water (besides driaing any water out of it)...
Thanks!...
And be sure to 'blow out' the water in the pipe after riding. When its on the trailer, rev it up a few times. You will notice the exhaust get louder and the amount of water coming out the ex...
I thought I had a bad battery, but I had water in the engine. It took a couple of weeks to find out.
I have gotten (I believe) all the water out. But it will not start. I have spark on all three...
...ere going to race. The answer was, 'STX's. Because they hook up and handle better in the rough water. The Ultras are much faster but dont hook-up aas well.' Personally I think the water...
...hore soaked ( stayed out for 1hour), it reminded me of when I use to ride the X2 this early in the year. Water was aroung 55, the air around 65, windy as hell and the sun was out. A couple of times I ...
... but time has not permitted me to double check the RPM's. I had just enough time to put it into the water, check acceleration and top end and beat on it in rough water to make sure that it would ...
...and bad counter balancing shaft and crankshaft. The cause of the problem was also diagnosed as the 'water regulator' went out and caused all this. What is a water regulator on a Doo? I have ...
...e idea as were my problem is. For starters I have a 97 Seadoo SP with a 717 engine. I'll get to the water and start her up, it runs fine. I take it out and have a blast the problem starts when I ...
...5yr old trailer which has recently had new wheel bearings fitted.
The ski has only been used on salt water once, mainly used on a fresh water lake near my house in Staffordshire. It has been relia...
Factory pipe spec 2 with race chamber and R&D Water injection. Setup with custom water routing ( same as Karine Paturel ) Billet through hull fitting for second water line. Custom gaskets included...
...oke motors are capablie of much higher RPM's. more rev's mean more speed. the problem i see is water inhalation! valves don't hold up to water in the chamber very well.guess we'll ...
... the hull doesn't taper up as 99% of the hulls do thus leaving the bow a little further down in the water. Trim can lift the nose a bit, but the ski will still want to 'nose-into' the w...
...as the main reason why i bought the thing cause i wanted something to plant the nose of the ski into the water just prior to the turns.. I am no racer but i do enjoy turning bouys when i ride.. I woul...
i have a polaris 150 pwc that needs a water pump. do i have to pull the motor to do that?
Water droplets? Could have been from your ride...but could be entering elsewhere (i.e. the fuel tank). Check your compression and if that is correct, replace the plugs and go from there.
My buddies GTi backfires too when blowing the water out. Runs fine otherwise. No reeds in the 720 though. It has the rotary valve.
... running head to head for hours today, we GPS'd the GPR at 63.9 and the yellow bullet (heads, pipe, water injection, prop, grate, ignition, etc.) at a blistering 64.5. As Gary said, .6 mph is fas...
The Content on this site is provided for general information purposes only. Your use of the Content, or any part thereof, is made solely at Your own risk and responsibility. By entering this site you declare you read and agreed to its Terms, Rules & Privacy.
Copyright © 2006 - 2010 My Jetski Buddies |
TIP: Write your question in details [ why? ]
Latest Posts
|
more posts...