throttle

Forum Post yamaha to SD throttle
ok guys quit lurkin, and help me out , when changing the thumb throttle off a sd to the yamaha finger throttle do you need anything else besides the throttle assembly kit yamaha sells, ? clips, bolts,...
Forum Post SD UMI finger throttle info
Does anybody know where I can get a good deal on a new or used UMI finger throttle/kill switch assembly? I'm looking for the one that uses the stock throttle lever. Thanks,
Forum Post Throttle Question II
Be sure to check-out http://www.coastalwatercraft.com Their Thumb-Saver throttle kits are top notch.
Forum Post Woking on an SXi Pro OEM carb fix
It is apparent from what I've heard and seen first hand, that there's a definite problem with throttle shaft cracking on the OEM SXi Pro Mikuni BN40-38 carbs. In my opinion, the problem ...
Forum Post HX JETTING
...he motor 'burbles' and takes a few moments to 'clear out' before it runs fine with good throttle response and plugs the correct color. when you are in the water you can slow to idl...
Forum Post 2001 Yamaha GP1200R ????
One other small detail comes to mind- the method of attaching the throttle cable barrel to the throttle is new and improved ) seriously LOL actually if you don't assemble yamaha boats at the deal...
Forum Post How do you Fog a Kawi 1100 DI Engine?
I would think the throttle body would be the place to fog.
Forum Post Carb Screw to Jet Size Ratio Question
...et. Are you sure it is the lows that are too big?? The highs being rich will make it load up too, on a full throttle grab from and idle. While on the trailer but in the water under load, lean down the...
Forum Post ONLY WHIMPS TALK ABOUT GOING FAST
My head is spinning! 83mph on a PWC is amazing!!! I think the throttle cable is being stretched because he is going so fast it must be a real feat to hold on !!
Forum Post Old kawa models compared
Hi, I'm buying my 1st jet ski for next season, and I've decided to buy kawasaki 550 or 650, since they are challenging enough but affordable. Anyway There seems to be shortage of 650 jet...
Forum Post 96 superjet fuel problem
...re in the tank through the vent and watching the inside of the carbs for any leakage. Make sure to open the throttle so you can see the low speed inlets also. Darin...
Forum Post Question re: Polaris SLTH
I rev up my skis and hold a steady throttle. Don't flush for more than a couple of minutes though. When flushing, your engine gets coolant but not the pump bearings like they would with water goi...
Forum Post Sea-Doo RPM drop question
...ichen up your carbs a tad. Cooler I have the plugs with a nice brown color doing my high spped kill the throttle runs. The RPM only drop when that damb regulator diaphragm pops loose. Aslo only th...
Forum Post Cracked SXI intake ???
...torquing to carb mounting bolts! I would suggest any owner to remove carbs, verify peened butterfly screws, throttle & choke, re-torque carb mount bolts to fact.specs. Lock bolts using fact. girdl...
Forum Post Help!!! Yamaha problems-need advice!!!
...nd engine does'nt stop when lanyard is pulled. Craft is now in the shop for the 3rd time. Also at full throttle the engine is now hesitating....Any advice on how to remedy my situation would be m...
Forum Post New Shred Master Ride Plates WEB site.
...it up for very aggressive turning! Yes, it is a very fast combination! It is great for starts, can hold the throttle wide open through the sweeping bouys! What I did not like: I am relatively shor...
Forum Post 96 SD XP No power at low speed, help please
...t 50mph, but has low power at lower speed. Meaning slow takeoff, (engine revs high though), cant blast the throttle at about 30 mph and do a spinning slide. Mechanic friends said (auto mechanic)...
Forum Post Ultra mysteriously has half power
...ere was a problem. I let it run for about ten more seconds, shut it off and started it again. I blipped the throttle a few times and right off idle there is a definate bog. It being such a good day I ...
Forum Post X-2 for sale in MA (goodys)
...ave an 88 X-2 this is the most reliable watercraft i have ever owned heres a list of the goodies finger throttle renthal bars primer kit reed stuffers jetsport intake manifold 38 mm mikuni westcoa...
Forum Post FS: Kaw parts
...39; impeller (Kaw 650) - $40 Mikuni SBN 44mm - $75 Mikuni Dual SBN 44mm w/ Prok atomizers (need new throttle plates) - $125 R&D intake manifold for dual Mikuni 44mm - $30 Keihin du...
Forum Post Wave venture 1100 Bill O, Harry K, anyone who might know!!
...bout 30 secs and then dies to a sputter for a bit then screams again [wot] this cycle is continuous. If the throttle is snapped open the boat will die. It needs to be coaxed to run fast. It will idle ...
Blog Post WaterCraft of the Year 2007
WaterCraft World magazine named the Kawasaki Ultra 250X as its 2007 Watercraft of the Year The item is taken from Bollman Yachts tiding I brought the information about it for you to enjo...
 

The Content on this site is provided for general information purposes only. Your use of the Content, or any part thereof, is made solely at Your own risk and responsibility. By entering this site you declare you read and agreed to its Terms, Rules & Privacy.
Copyright © 2006 - 2010 My Jetski Buddies