My ProfileBloggers Wanted
We're looking for people to help with the main blog.If you are consistent, knowledgeable and you're into it, please drop me a note. |
speed
...- To suit the new 155mm jet pump, a larger impeller was designed, offering improved thrust in the higher speed ranges
- The sophisticated three-blade unit delivers both high performance and quiet op...
...turns and stuff, gets upto about 50mph.
The second, gets upto about 50mph, but has low power at lower speed. Meaning slow takeoff, (engine revs high though), cant blast the throttle at about 30 mp...
i'm looking for a new aftermarket impeller for my 2001 1100 stx di. i'll probably prefer the top speed over the holeshot type but i'll entertain either. i'm not picky on manufacturer as long as it's n
...on restart i let idle for a few and if throttle is babied until wide open position I get full pickup and speed.where should i start to diagnose this problem? it still has the stock fuel pump/w pulse l...
I recently bought a 96 Kawasaki 1100 ZXi and I was wondering what the top speed is. The previous owner only changed the water intake. With little 150lb me on a calm lake, it went 68mph. Are these spee
...e trailer...not so good in the water.
Took it out, but it was bogging pretty bad. I could get it up to speed eventually, but would take a while. Any tricks would kill the motor and make it hard to s...
...with one person, makes the ski undriveable with two people. With a passenger, it can't get up to planing speed. What is the most likely cause on a ski that's this new? I have the feeling that the driv...
with 56.8 hours I noticed I was slowing to a max speed of 64mph. Upon dissasembly of the pipe I found the cone of the cat wedged into the rideplate.
The engine was also showing an overheat warning l
...ner says it has low compression in the rear cylinder (2 cyl engine). It does run a little rough at lower speeds, but fine when you open her up.
Just wondering if anyone had some ideas. One thought i...
I bought a 98 Polaris SLTH Friday & it runs great & Looks new. 1 problem. At high speeds the forward/reverse lever vibrates like mad making an awful sound. Looked at the back where the baffle(?) is &
...tive note, the idiot that had the JetSki before me was running BPR6ES plugs in it, when running at lower speeds the unit exhibited some flooding symptoms. It ran fine at RPM's over 3500 but at 1300-28...
I need a speedometer for a 95 GTX. Any of the earilier years should work, except for the XP. It is a different kind. Need to know if any other model will workl.
Thanks
Garmin Etrex Vista GPS used to get the speed. The thing is dead on with my speedo in my truck but, in all fairness, I don't know how accurate the speedo is.
Time: 7:30 AM Location: North end of Lake
...settings.
The ski hesitates out of the hole.
It has a westcoast pipe and hotbox waterbox.
The high speed screw is all the way in and the low speed is 3 turns out.
Motor is a 587 cc.
Any Idea...
...hey liked the sightseeing aspect versus the thrill ride,but I gotta wonder what would happen to add some speed to the experience.I know that it is not designed for that but I still wonder if it would ...
...flood the engine BUT... has anyone put a valve on the 'pitot' tube hose so that the unit can be towed at speeds between 20 and 25 KTs? I have a jet Dingy (Nautica) that had a yamaha 760 Jet engine for...
...idle at a slightly higher rpm (by giving it a small amount of throttle - that is to say increase my idle speed from 2 mph to 4 for instance) it will take off just fine.
A little more info. Had it to...
...even.
It seems that the STXR does about 63 MPH stock, but unlike the GPR, it does roughly the same top speed in glass or good sized chop. Of course, I now want to start doing some mods to it to see ...
...est on page 64 june 2002. It puts the noise of the Honda at 83 db and the Doo at 78 db Yamaha 79 db. Top speed of the Honda Turbo is 57.9 the Doo is at 55.9 and Yamaha at 55.2 This is a good mag. Boat...
...da too. The power and torque of the Honda of course is superior but I have to ding the Honda on its high speed ride in midly rough water. It is a harder, more jolting ride and perhaps the pump is not ...
... TO INSTALL A SET OF PROK FILTERS ON MY 99 SPX WILL I NEED A JET KIT OR CAN I TUNE IT WITH JUST THE HIGH SPEEDS? IF YOU HAVE SOME JETTING SPECS LET ME KNOW . THANKS IN ADVANCE....
Have a 96, engine sounds good, has little power in the water, top speed about 20. Head pressure is good, any help would be apreciated.
...y new Sea-doo GTX-DI (28 hours) started right up and runs great although the electronics is limiting the speed to 35mph because of this problem. I did not charge the battery first, but it started righ...
Anyone know if another years speedo will work with a 95 GTX. Dont know if the hole size is right. The ones I have seen pictures of have the right wires and connectors. I do not know if the sender unit
...and use the same impellers). I'm just trying to improve the bottom end hookup without losing any top end speed.
Thanks,...
...ts rock solid and smooth as glass. What do I look for to try and get this fool thing to run between idle speed and the magic 2500 RPM without having to all out dog the gas to get it to run ? Idles ok,...
... it seems unnecessary. I think part of the fun of a PWC is having no rudder. 3) Relatively high idle rpm/speed. More difficult to dock than previous models owned. More difficult to reverse quickly. 4)...
... of Ocean Pro flame arresters for a 96XP. Do I have to rejet or can I just turn up the high (and or) low speed screws? I live in GA....
...dification that would give it more lateral stability? Is this one of the purposes of sponsons? I'm not a speed demon so I don't care as much about speed as I do about stability, but I don't want to pu...
...e accident and added that he did not expect any charges or tickets to result from the crash. There is no speed limit on the lake in the afternoon.
The man died from the impact of the collision, not ...
...B.
They say that this prop is used with the washer/spacer left in. I guess it is supposed to offer top speed similar to the 14/20 with acceleration near to the 13/19. My GPR was going to require a f...
...you ask me. The 96 XP is a hella good looking ski!
Wave jumping!!!! Which one is the better one?
Top speed!!! hey I might wanna mod this SD to tear up or at least give a good race to those damn GP...
...w reves then if I give it throttle she rev's 6000-7000 with very little foward momentum but if I pick up speed slowy it get going ok...just slower to get up to speed. someone said I might have some sh...
It should have the weight of a FX1, the acceration of the superjet, and the top speed of a SXI.
... and v-force reeds. Evidently the jetting needs have changed enough to point where I had to open the low speeds all the way to get it to run on all three on the trailer!
Thanks,...
...problem to have (hard to diagnose). Every so often it would lose all power and just wobble along at idle speed while everyone else raced on. My buddy Greg offered to rebuild my carbs which was nice of...
...n crowded surf jumping fifteen foot waves to wear helmets. What about people that do nothing but 60+ MPH speed runs all day on empty glass lakes.
Also, without going into too many gory details, I wo...
Ok TEAM NG,
What is the favorite tripple pipes of choice and why?
I hear that the Speedwerx pipes make about 8 more hp, but are more prone to detonation being that Darrin at Speedwerx doesn't have
wondering if anybody has tried it and what they got for top speed on gps or radar.is this the best way to go for a rec rider looking for just the highest top speed in a easy bolt on kit
In the real world, do the V-Force reeds add any top speed? I know that all models probably react differently, but generally speaking, all other things being the same,do they deliver better top speeds?
Can somebody tell me the topspeed from the SEADOO 4-tec ALSO THE TOPSPEED OF THE NEW 2002 SEADOO GTX DI..???? THANKS A LOT
ive got a 98 model gp800, does anyone else have the problem of it porpoising badly when building up speed? even with the trim adjusted with the bow down it still does it.
... stuff, it carves very well, my opinion probably the best all around rec ski. SuperJet is great for high speed runs, not as sensitive to rider input. Any questions email me...
Page: 1
|
Latest Hot PhotosLatest Posts
|



