My Profile

Keep Up to Date:
Blog RSS
Blog
Forum RSS
Forum

pull

jetski took on alot of water pulled plugs it is pumping water out of 2 of the 3 cylinders will it dry out or am i looking at the shop and a big expense?
...TX and a 2001 Seadoo RX. both pairs have about 48 hrs on them. I'm looking for a pair of ski's, one for pulling tubes and cruising and the other for faster, wave jumping and cutting. I currently have ...
... the engine rebuilt. I put a water sensor alarm in the intake manifold. The sensor detected water after pulling the jetski from the water and sitting on the boat ramp with the engine purging remaining...
...he water, it idles just fine and when you give it gas, it revs up just fine. But about every 3rd or 4th pull of the throttle, it will start to rev up, but then bog and an inline spark tester shows tha...
...e has less than 20 hrs last year , 2 hrs this year completly pump gas safe you can check compression or pull the head ( bring o rings) drive train will bolt up immediatly to any gp hull ( if you dont ...
...he water, it idles just fine and when you give it gas, it revs up just fine. But about every 5th or 6th pull of the throttle, it will start to bog like it's getting flooded. When it happens, you can l...
...e yanked the engine (all 499 cc of it) and cant get the driven shaft out of the bearing housing. I also pulled the three bolts out but the housing wont come out either. I don't want to reef on the thi...
...0 to have it repaired - is this a reasonable amount? Also, if I decide to fix it myself, do I need to pull out the drive shaft and its bearings and seals or could I remove just the nozzle, impeller ...
...drained the oil tank in case there was water in there (didn't find any) and fiddled with the crank-case pull-thingy (whatever that's called). In doing so I noticed that 2 motor-mounts were broken and ...
...erday for the first time. My son turned it over within 30 seconds of getting on it with a friend. After pulling the plugs several times and wiping them dry, we got it running and had no further proble...
.... Was able to coast it over to the beach, popped the seat off and opened the hood. It cranks fine, so I pulled off a spark plug wire and used a key to check for spark. I usually don't have to much to ...
...own that street available for neighbors but only for seasonal launching an maintenance, can't use it to pull the pwc after each use). Also, when I got the pwc they told me to try not starting in wat...
...ock boat. With him on the near stock STXR and me on my TSI CEP GPR (w/ Advent CDI) in 1-2 foot chop, he pulled me about 4-5 boatlengths out of the hole from a dead stop and I could never recover. Of c...
...on the 96 Blaster with the mods you mentioned. But, only the 96. The 96 has the raider cased motor that pulls more air than the older 93-95 model year blasters. If it was a 93-95 model, you would be m...
...beeps. Checked and cleaned all the fuses. New plugs. Anyone got any quick ideas before I start really pulling it apart. Thanks much!...
...get it to start.Since then I have fixed the flywheel boot problem but now I can't get it to start. If I pull the plugs it will turn over but if I cover them with my finger it stop turning and start cl...
...in Nov 2000. The cover on the engine and the owners manual calls for BR8HS plugs gapped at .024. I just pulled the plugs that are currently in it and they are BR8ES-11 gapped at .40. I now want to rep...
...nd reg to show up. Bottom of hull is purple, motor is yellow. Hasn't been wet since '96. Previous owner pulled motor out to replace starter. I'm not sure he put it back together properly. Motor has go...
...s hoping someone could give me guidance on. I am having problems with my '92 Waverunner III 650. When I pull the throttle back more than 1/4 of the way, I am getting no power, and almost sounds like t...
...is ski? A few years ago I had a cavitation problem and a friend of mine who knew how to remove the pump pulled it and said my stock impeller was in bad shape. I bought a new wear ring and he installed...
...athing suits, and some kick ass racing. The closer to completion my ski gets, the more I feel the force pulling me down south.. I got to have some round 1 NOW.. Any one with me?...
Well I am 190lbs ricky g!! Whats your point?
...0km Seadoo challenge today on Botany Bay ,Sydney Australia! And the winner was a STOCK GPR , yes it was pulled down and checked after the race and passed the inspection . There were some fast XPLs out...
Page: 1

Copyright © 2006 - Nov 2008 My Jetski Buddies