My Profile

Keep Up to Date:
Blog RSS
Blog
Forum RSS
Forum

plugs

jetski took on alot of water pulled plugs it is pumping water out of 2 of the 3 cylinders will it dry out or am i looking at the shop and a big expense?
I have had several Seadoo's and a common problem is at starting. The motor turns over with the spark plugs out of the head but won't turn over when the plugs are in. I have changed starters and put in
...he throttle at about 30 mph and do a spinning slide. Mechanic friends said (auto mechanic) to check plugs. Well I had already changed the plugs once, but did it again just to be safe. Also said...
...go by a well known mechanic so I feel fairly comfortable that it's not an engine problem. Also the spark plugs are new but they are getting black and slightly wet when I examine them. I have rebuilt...
I have a 2000 Seadoo GTX that has fouled out two sets of plugs in the last three outings. What causes this and what can I do to prevent it? I run 89 octane and NGK br8es plugs per specs. I use Bombard
...rner on it now. Won't go over couple-thousand RPM. Top speed 20mph with no bottom end. So I change the plugs to see if that helps, but it doesn't. Funny thing though, when I took off after changing ...
...he first time. My son turned it over within 30 seconds of getting on it with a friend. After pulling the plugs several times and wiping them dry, we got it running and had no further problems. Now my ...
...ding has been in salt water (bays and on ocean). The Blaster is well maintained, no oil residue in hull, plugs changed/cleaned every few runs, using good quality lube and gas, never had a engine or el...
...ow to find this leak??? On a positive note, the idiot that had the JetSki before me was running BPR6ES plugs in it, when running at lower speeds the unit exhibited some flooding symptoms. It ran fin...
I'm installing new plugs in my 91 SeaDoo SPi's. The engine is a 580, 7cc Rotax. I've been told conflicting info from two different area mechanics. One has told me to gap the plugs at 0.50 mm, 0.020 in
...at the rear compartment (above rideplate) has been taking on some water - i thought it might be the drainplugs - so i replaced... however, last night the whole compartment had filled up with water and...
...eventually slows down to about 10 mph. I had the carbs rebuilt about 2 months ago and I have changed the plugs. The first time I noticed it I also found that one of the exhaust bolts had come loose an...
Hi all anyone ever use the platinum spark plugs in a wave runner? or has anyone ever put racing fuel 110 octane+ in a stock wave runner? Thanks
...eperator, but that did nothing for it at the time. Always fresh gas, good oil (Maxima Marine Pro), clean plugs, etc. It is completely stock. So, Would the exhaust manifold really cause this, or coul...
... spray lube into the cylindars and crank the engine to spread the lube around - then re-insert the spark plugs. Won't this lube foul my spark plugs the next time I crank the unit up ? Should I use a s...
We have a few cases of BR7ES, BR8ES, and BR9ES we are selling them for $16.50 for box of ten. The shipping charge is $4.95 in the U.S. You can call or email me for questions or to place order. Der
...rt because of lack of spark. Battery is now new. I get 2 beeps. Checked and cleaned all the fuses. New plugs. Anyone got any quick ideas before I start really pulling it apart. Thanks much!...
...o start.Since then I have fixed the flywheel boot problem but now I can't get it to start. If I pull the plugs it will turn over but if I cover them with my finger it stop turning and start clunking a...
...y an authorized Yamaha dealer in Nov 2000. The cover on the engine and the owners manual calls for BR8HS plugs gapped at .024. I just pulled the plugs that are currently in it and they are BR8ES-11 ga...
...d. Could this be caused by the feed/drain hoses on the exhaust pipe being reversed? I cranked motor with plugs out to get water out, do I still have to pull the drain plugs? 4. Wire colors in wire h...
...n 1/4 of the way, I am getting no power, and almost sounds like the engine just goes blahhhhh. I use new plugs, and the ski runs fine for about 3 or 4 minutes, if that, and then does the same thing ag...
...about 2700' elevation and according to my thermometer/hygrometer outside, 92* with 40% humidity) and the plugs are rich. I'm thinking excellent, no problems but why the buzzer. A light goes off in my ...
I had the same problem, some sta-bil, fresh plugs and 2 tanks of clean gas did the trick. Was the ski stored over the winter and you're just taking it out for the first time? R
...models (riden WOT most of the time) anyone know about this mod, or how to do it. also istead of checking plugs for the correct mixture, am I supposed to be looking at the piston tops instead? (bare al...
..., same pump, impeller combo; everything is the same.....except for the motor. What could cause this, the plugs look to read fine, the tach holds steady...I just cant for the life of me find my other 3...
Has anyone had any experience installing these plugs in the 1200R. If so what is the recommended silicone to use? I want to make sure that they stay put once their installed.
...back fire. It has a good stong starting sound and the fuel is flowing. I checked for spark (grounded the plugs on the head) and it only sparked one time every 3 seconds. Laszlo at Carolina Water Works...
Page: 1

Copyright © 2006 - Nov 2008 My Jetski Buddies