pipe

Forum Post Rossier Pipe For XPL?
With the Rossier pipe on my Limited XPL at WF, I can say that a young little 100 lb girl beat me to the first buoy by 2 boat lengths.Her boat was equipped with twin pipes. 2 laps later I easily passed...
Forum Post wtb 951 coffmans pipe
look to purchase coffmans pipe for 98 xpl also water injestion for same boat Before you buy.
Forum Post Do you have a 951 pipe FS
looking for a 951 coffman,perferably without the rev limiter for xpl e-mail me a price
Forum Post Factory Pipe/Super Jet question
Can the old style and new style Super Jet hulls use the same Factory Pipes? Just wondering if they are interchangeable.
Forum Post Sea-Doo RPM drop question
I agree, but don't couldn't it be possible that the steam created in the pipe jacket could work it's way back down to the waterbox valve causing the expansion? There should a clamp at t...
Forum Post FS: Seadoo 785 Race parts
Factory pipe spec 2 with race chamber and R&D Water injection. Setup with custom water routing ( same as Karine Paturel ) Billet through hull fitting for second water line. Custom gaskets included...
Forum Post Parts for XPL 99
Have Coffman pipe, $300
Forum Post Aftermarket carbs for 99 Sxi Pro..advice needed
Dump the WC head but keep the pipe.
Forum Post X-2 for sale in MA (goodys)
... throttle renthal bars primer kit reed stuffers jetsport intake manifold 38 mm mikuni westcoast limited pipe(most h.p. pipe they made) westcoast racing exghaust manifold new battery this season skat t...
Forum Post F/S Brand New S/D 951 Short Block $1400
Thanks Doug; I sold the motor to someone else anyway. Good info for later. Doug do you still need a pipe? I have a Coffman and Factory Twins.
Forum Post GPR: Help me find my RPMs!!!! The Cure
... will save us all a lot of head scratching! << The cat. con was found in the very back of the pipe, instead of where it was suppose to be. >> Mario temps are falling? ...
Forum Post 99 XPL whats next
Keith, The Coffman pipe with a re-programmed oem ignition ( I can get that done) and repitching the impellor is the next logical step for speed. Leave the reeds alone. OEM reeds are carbon fiber and t...
Forum Post rusted spark plugs?
And be sure to 'blow out' the water in the pipe after riding. When its on the trailer, rev it up a few times. You will notice the exhaust get louder and the amount of water coming out the ex...
Forum Post HX JETTING
...ched impellor. Or, try using larger low speed jets and smaller high speed jets. If it has a Factory Pipe on it, increase the headpipe water by using the adjuster on the headpipe. Bill O'N...
Forum Post Speed Ideas for 650sx
...on me to catch up. I have no problems with endurance, just with a slow boat. I have already purchased a pipe, flame arrestor, waterbox, new head gasket, and primer kit. Anyone have any other suggestio...
Forum Post HX vs Waveblaster (help)
it doesn't take much money at all to get about 100hp out of that motor. a nice head, a good pipe, some reeds and possibly some ignition work would put pretty close to that kind of hp. a little po...
Forum Post cold water and no T Stat
...ct operating temperature of the engine by using restrictor jets in the water by-pass going out from the pipe. In your case, you might be able to put a thermostsat into the place where it normally goes...
Forum Post FS: SeaDoo and Mikuni stuff
...iter work on a stock 800 , does it just hook up or do you need something with it , i am running a stock pipe ,xi prop, with k&n filters, also have some kawi 750 parts if you want to trade, if it t...
Forum Post Cracked SXI intake ???
...ty. Then i switched to new carbs and intake manifold. If you do any kind of other mods to your ski like pipe or porting i would suggest new carbs over the stock carbs any way. I have a side draft mani...
Forum Post FS: SJ parts, not mine
...t plates should be nice, especially at that price.... http://www.rayceinc.com/USEDPARTS.htm 1 R+d dry pipe w/secrets Almost new 900.00 1 6 vein magnum pump Good 625.00 1 62 mph superjet full...
Forum Post Triple Polaris Pipes HELP!
Ok, I need some help here. I have a Polaris Pro 785. Polaris is selling a new set on triple pipes made by Moto Marine for the Polaris Pro. Does anyone have any experience with this pipes. Hot Seat...
Forum Post How much would you spend?
...te of running head to head for hours today, we GPS'd the GPR at 63.9 and the yellow bullet (heads, pipe, water injection, prop, grate, ignition, etc.) at a blistering 64.5. As Gary said, .6 mph i...
Forum Post Farthing Racing 2001 Team
...as of this press release: Yamaha Motor corp, Ford Truck Division, Farthing Racing, Riva Yamaha, Factory Pipe, Umi, Skat Trak, Msd, Hydro Turf, Maxima Oil, Cti Knee Braces, Jet Trim, Jet Pilot, Smith O...
Forum Post FS: SEADOO PARTS
ALL SEADOO 800 PARTS VTS MODULE-40 STOCK HEAD, COVER-50 EXHAUST MANIFOLD-25 EXHAUST PIPE-40 WATERBOX-50 39CC ADA DOMES (BRAND NEW)-25 PAIR TWIST RIDE PLATE-20 GAS TANK AND SENDING UNIT-50 OIL TANK AND...
Forum Post Standup Riders... Need for improvements in standup skis!!
...2000 Superjet yesterday and it was as much adrenaline as I could want. Plus I've still got a head, pipe and a prop to install....
Forum Post ONLY WHIMPS TALK ABOUT GOING FAST
Others, JUST DO IT! ABSOLUTELY PERFECT! MALAN WINS GRAN PRIX FINAL Lake Elsinore Shines Lake Elsinore, CA - November 18 - On what had to be considered Chamber of Commerce weather, the final ra...
Blog Post WaterCraft of the Year 2007
WaterCraft World magazine named the Kawasaki Ultra 250X as its 2007 Watercraft of the Year The item is taken from Bollman Yachts tiding I brought the information about it for you to enjo...
 

The Content on this site is provided for general information purposes only. Your use of the Content, or any part thereof, is made solely at Your own risk and responsibility. By entering this site you declare you read and agreed to its Terms, Rules & Privacy.
Copyright © 2006 - 2010 My Jetski Buddies