performance
I plan on having the team at the Livingston race. Hope to see you guys there!
James Crone Performance Engineering http://www.Performance-Eng.com
...ouldn't install a primer. There was a TSB on hard starting that your dealer can remedy...
James Crone Performance Engineering http://www.Performance-Eng.com ...
...as a pair. Each is pre machined from the factory to match the other (where they bolt together.
James Crone Performance Engineering http://www.Performance-Eng.com ...
...39;96 with an ADA motor that broke, seized and wouldn't run.... I wonder who THAT was...
James Crone Performance Engineering http://www.Performance-Eng.com ...
...o you may need different jetting than the generic settings/jetting that Aquasports recommends.
James Crone Performance Engineering http://www.Performance-Eng.com ...
...
SBT might sell you one outright (if yours is chunked) but I haven't priced one there...
James Crone Performance Engineering http://www.Performance-Eng.com ...
Cramer, Novice ? What happens in Novice classes is usually dictated by the quality of the rider, more than the performance of the ski. There are way too many varibles to judge performance parts from, ...
...n't much to it except for one very telling statement from Honda 'designed for the family and not the performance oriented enthusiast'. Kind of tells you Honda isn't getting the kin...
Has anyone tested the Shred-Master ride plate for the Ultra yet? I am interested in it's performance and what other bolt-ons (intake, sponsons, etc.) were used with it.
Thanks,
I am considering a Magnum Pump for my 1996 superstock Superjet. Any information about performance gains would be appreciated. I talked to the people at Skat Trak and they had no actual top speed or ac...
...very helpful.
I wonder if that little addition to the stinger is enough to make a marked difference in the performance of the stinger. Mario temps are falling? ...
.... My wife wants to see if I am lying, but your girlfriend looks alot like my wife. My buddys were walking down performance alley and saw her and came to get me to show me that this person looks like m...
Thanks! I know I won't gain anything in WOT performance but the boat loads up pretty quick at idle so I was hoping to correct that by going up on the pilot jet & in with the screws. Someone j...
... not IJSBA legal, so there is a way to eliminate it and, at the same time, tune exhaust temperature for mximum performance. The Sea-Doo race manual explains in detail. Good luck....
... pro 1200 title was won on a privateer sea-doo against facotry kawasaki. The Sea-Doo was equipped with a Perry Performance Group powerplant. I think you are much better off with a sea-doo....
...or them. Other than promoting events, announcing for the IJSBA, color commentating for Speed Vision, and BEING performance alley for the last 2 years on the national tour. Ya maybe you're right H...
...ou did with the cat. I have noticed that engine compartment temperature does play an important part in overall performance. I'm surprised that you didn't see a rpm improvement. Did you have ...
... of wetted surface, but installing a lighter prop, or boring the nozzle will increase the low end and midrange performance without losing the .5 to 1.0 that you gained.
Bruce Wolford Wet Wolf Tech...
...;t figured out what to do with it yet. I may try to teach my 10 year old to wake board...
Any suggestions on performance upgrades or any info in general I'm all ears....
...hey just patch it up or redo the whole engine....for the money that we pay on skis and all that expensive high performance oil and other goodies i would expect a little bit longer of a run....like may...
...alled properly Has CV carbs stock.. A bit cold natured in the mornings but this boat always had better top end performance than its 98+ STXs Boat hits like a hammer off the line..
Not a scratch on...
...did run 65 with his wife on it. Gary seems to have put on a few pounds over the years and it shows in the skis performance - hahahahahaaaa. He lets me ride the little yellow beast and it got me real c...
...y high quality, hand crafted (ported and polished, rather tuned!), perfectly true. If you want to increase the performance you can 'tune' it up for very aggressive turning! Yes, it is a very...
... intake that should work:
231-75144 KAW. 750 HIGH VELOCITY DUAL MANIFOLD, MIKUNI 44/46mm
http://www.rd-performance.com/search_kawasaki.asp
Just use 44 Mikuni carb base gaskets with your O...
I have a killer exhaust FS for the SXi if you are interested - It is definitely THE top exhaust performance-wise for a Limited mod SXi - Coffman's Signature series Dry exhaust w/ water injection....
...ter line. Custom gaskets included. Pipe has about 3 hours on it bought and used for world finals. $650
RAD Performance Charging Lightwieght 785 flywheel $100
R&D 82mm venturi nozzle $75
...
...SXi (75 hp - dual carb). 75hp is (IMO) quite adequate for most people. Most diehard owner would go aftermarket performance mods if they need to increase the horse power beyond stock.
I would hope ...
...OOST R.P.M. GET INTO THE PROGRAM!
Cantil, CA -
We are delighted to report that R.P.M. RACING (Renegade Performance Products), of Phoenix, AZ has joined the growing list of series sponsors, to ...
I have a couple things left after selling my Doos and other aftermarket stuff. I posted these items with pictures in alt.binaries.pictures.jetski if you want to take a look. All prices INCLUDE shippin...
It is apparent from what I've heard and seen first hand, that there's a definite problem with throttle shaft cracking on the OEM SXi Pro Mikuni BN40-38 carbs.
In my opinion, the problem ...
The Content on this site is provided for general information purposes only. Your use of the Content, or any part thereof, is made solely at Your own risk and responsibility. By entering this site you declare you read and agreed to its Terms, Rules & Privacy.
Copyright © 2006 - 2010 My Jetski Buddies |
TIP: Write your question in details [ why? ]
Latest Posts
|
more posts...