My Profile

Keep Up to Date:
Blog RSS
Blog
Forum RSS
Forum
Search

Buy & Sell

Used (Like New) $20

Post New Topic Post Reply
Posted 10 Months, 2 Weeks ago
Kclhmtguh
Senior Boarder
Posts: 45
graphgraph
User Offline
 
I have a 99 ultra went out today and found that my gas gauge was not working . I check all the conections and they are all good .fuel light on panel just flashes like im out of gas but its full . ,also warning light flashes with fuel gauge .any ideas
The administrator has disabled public write access.
Posted 10 Months, 2 Weeks ago
kckempf
Junior Boarder
Posts: 33
graphgraph
User Offline
 
make a jumper lead and cross the two sender wires.If it reads full your sender is bad.Scott
The administrator has disabled public write access.
Posted 10 Months, 2 Weeks ago
Matroskin
Senior Boarder
Posts: 53
graphgraph
User Offline
 
is this hard to get to were is the sending unit and is it easy to change .sorry for the dumb question just dont know.
The administrator has disabled public write access.
Posted 10 Months, 2 Weeks ago
johnholland
Senior Boarder
Posts: 54
graphgraph
User Offline
 
look on top of the tank and you will see the sending unit[black rubber with wires sticking out.]As far as changing it sometimes you have to pull the engine and then slide the tank out.On the ultra I have not been able to pull one out with the tank in.Good luck,scott
The administrator has disabled public write access.
 
Copyright © 2006 - Jan 2009 My Jetski Buddies