fuel
1997 Sea-Doo GTX. Over the summer, the fuel gauge on the Info Center started only reading 0 - 1 bar whether the tank is full or empty. I figure a magnet fell off of the sender? Anyway, is it possible ...
...rises, the air in the gas tank can expand and create quite a bit of pressure.This in turn forces excess fuel into the cylinder and ultimately , the crankcase...just every now and then crack open the f...
dose any one have a source on parts for the mrd fuel injection set up? 'ie' pump rebuild kits ect.. thanks bob
my superstock superjet uses 44 sbn's and delivers excessive fuel to the crank/cylinder when the motor is not running. anybody have a solution?
I guess I just forgot to post this, it happened a while ago, and I havent fixed it yet:
The fuel tank in my hx has somehow come loose. The metal plate that should be attatched to the inside of the...
...hour or so, they'll run fine for awhile again and then stall again. Any ideas what could be wrong? Fuel filter, etc. good - I think it's a fuel problem because you can smell fuel when it hap...
The floats in most polaris fuel level sender units can actually crack the outer skin on the float, this allows the float to fill up with fuel and sink. The good news is that you can buy the float sepa...
You might want to try and richen up your carbs a tad. Cooler temps require slightly more fuel. A slight lean condition will reveal itself with lower RPMs at first. Sounds like you are close, but a lit...
...on, IL)(970033T) Year: 1993 - 1995 Models: 1995 GTX (ALL) Units: 126,228 Problem: Potentially defective fuel filler necks may cause fuel leakage; possible fire/explosion if ignition source present
...
Depends on which carbs you have, push-in are for SBN 'square' body fuel pump carbs. Screw-in are for old style BN 'round' body fuel pump carbs. SBN carbs came out around '90 +...
It is possible that you Polaris had a fuel leak into the motor either by a jammed needle and seat or from expansion in the fuel tank causing a needle and seat to leak. This will fill the crankcases wi...
I meant the bowl seperator on the main fuel line. It's clearAnd yes, in canadian bucks. Worthless as it is.
Water droplets? Could have been from your ride...but could be entering elsewhere (i.e. the fuel tank). Check your compression and if that is correct, replace the plugs and go from there.
...skis. What do I have to do to winterize them besides removing the battery and putting stabalizer in the fuel? Any suggestions would be appreciated and please respond to my E-mail.
Jet skier in Ohi...
Drain the fuel tank and refill with fresh gas, or add some isopropyl alcohol (known to let the water dissolve in the gas)
Hope this helps.
...shaft couplers $25 each (3)
PTO (98) $25
Magnito $75 each (2)
Stock Flywheel $75
Mikuni Fuel pumps $25 each (2)
Starters $75
Stock Exhaust Manifold $70
New Ported 951 Cylin...
... The set was removed after 15 hours of use. Replaced with 44's. Need the intake,too? How about the fuel pump?...
Not really, It's a nice two seater that gets great fuel milage. It won't be nearly the fastest on the water, but it does ride decent and is very stable for two people. If I were to add somet...
... above ski? I am looking for a first ski... would this be a good ski? What is the range of this ski and fuel tank capacity? Anyone have any photos of one? Thanks...
... with old style Delta's can't be beat period. Dual 46mm novi's second....
However if fuel consumption is important, stock reworked carbs offer fine perf.. I used all three with grea...
Leaky needle and seat in the carb? Anyone else think so? Next time, before you get on, turn the fuel to OFF, get on normally, then turn it back on and see what happens. If that fixes it, it's pro...
...tart from cold once we have got it started it runs fine all day??? i think it may be a problem with the fuel supply , the tank seems to be under too much pressure as when i remove the gas cap you can ...
...l the water out. But it will not start. I have spark on all three cylinders, good compression and the fuel pump is working.
I hope nothing damaged, I have a shop manual and replaced the starter s...
I always thought a WANKEL or ROTARY engine would be a good replacement to the current 2 stroke. A fuel injected ROTARY has great power to wieght and should be cleaner than a 2 stroker... Also the rota...
... on all 3 cylinders New plugs too. Reeds are unchipped and seated well. Carbs are rebuilt, new pump for fuel pulled down 3 times since. Fuel lines have been blown out. Tank has been checked for water....
...at industry that OMC has filed for bankruptcy... what will this do for Kawasaki and Polaris?? the Ficht Fuel Injection is produced by OMC from what I understand or a OMC company. Kind of makes you won...
... painted trailor for 3K!! I must say so far it's been a blast. I've hit 64 with a half full fuel tank and the thing seems to have very quick take off..
I really haven't figured out w...
...heating up to temp. I could get my RPM's to about 4700-5500, and that was all.
I looked at the fuel delivery issue (dirty filter and bad fuel valve) and that helped me get all of my speed bac...
...ally if bore to piston clearance is tight. I like to see 120 F on avery engine. Do not forget to set up fuel delivery according to RAD. PS. Do not fall for the popular but terribly misleading statemen...
...ter the bottom end is clear, then you can proceed to the highs. The low speed circuitry always provides fuel. It is not an 'either or' circuitry...it is cumulative....
The Content on this site is provided for general information purposes only. Your use of the Content, or any part thereof, is made solely at Your own risk and responsibility. By entering this site you declare you read and agreed to its Terms, Rules & Privacy.
Copyright © 2006 - 2010 My Jetski Buddies |
TIP: Write your question in details [ why? ]
Latest Posts
|
more posts...