engine
I have a Polaris 2 cylinder engine that I need to replace. Anyone have a good source for a rebuild? Im located in Florida.
Thanks
Check out SBT http://www.enginenet.com/ . They are a well known PWC engine supplier..
Charlie Z
...rned a certain way over if its upside down so the water will flow out of it if any has accumulated in the engine department. Otherwise if you start it and it has too much water in the compartment it w...
Selling 1997 HX Hull with engine less head/exhaust/carbs with UMI steering, Skat-trak prop. $700.00 OBO
...be replaced. We have been told that these pumps have a tendency to quit unexpectedly resulting in a wiped engine. Any comments would be appreciated....
1996 model.. 110 hours 110 horses too I believe 787 engine
why you ask?
I just started my 2005 Polaris MSX 150 in my garage to get ready for a river trip and the check engine light would not go off and the over heating light came on. I am concerned.
...rs are compatable and anyhting someone thinks I aught to know for putting it all back together with a new engine or --rebuild kit--??? Thanks!...
...from someone who I am associated with that has ridden both of them.
The 2001GP1200R- This is the same engine as what was in my XL1200Limited (155hp 1200), and according to the dealer I bought it f...
...2004 Polaris MSX150.
How do you flush a Ski and should you always connect a water hose when starting the engine out of water ??
Regards Eric...
Actually, the 1990 550SX is an anomaly as it has the piston port engine, but the newer driveline and pads. I'm with Erik as I would take a 550 over a 650 anyday. I actually just sold my 750SXi to...
best I could do with a 650sx was around 57mph. It had a fully modified stroker 800cc engine 4 inch extended pump msd total loss dual 47 buckshots and a custom tried and true hull now my wifes limited ...
I have bought a 96 Doo and am putting an SBT engine in it, but I must remove the flywheel and pto before I return it to SBT. I understand the pto comes of by turning to the left. Do you heat it or bea...
...ter at the '300' also at Lake Elsinore, December 16.
What's next? Next year a 4-stroke engine with a quick tranny and two gears. 100 mph is not that far!
BPMS ...
Can someone tell me the correct way to line up the drive line after installing a new SBT engine. I get a high speed vibration that Im sure is drive line related when I rev it up. I do not have a long ...
Sorry that you had to go through the trouble that you did with the cat. I have noticed that engine compartment temperature does play an important part in overall performance. I'm surprised that y...
... and two stroke oil. It wasn't really anythin overly impressive with performance but it was a wankle engine....
...wather intaque included the impeler housing if that is ok make sure the impeler is the recomended for you engine...
...ot concern ourselves with motor mounts yet and address the question of hooking the pump shaft to the kawi engine. Anyone ever tried this? Anyone have any suggestions on other motor set ups? There is e...
James Time quires many illnesses. MSV set at 44.5 s/sec. How long do you think any engine will lest? Volume very 1.5 cc between cylinders. Good news is, NO HAND GRINDING ON HEADS. Unbelievable. David ...
...good - I think it's a fuel problem because you can smell fuel when it happens, but everything in the engine compartment looks good....
...ockage, or it's too lean.
BTW ciocca, the majority of the water for the pipe is supplied via the engine, through the exhaust manifold and into the top of the head pipe....
... Is it common or am I just lucky? The front carbs left mounting boss completely broke off (looking at the engine from the intake side). Does anyone sell an aftermarket intake that will fit the stock I...
...ed all this. What is a water regulator on a Doo? I have never heard of such a thing. I will be seeing the engine this weekend to see if I can help my buddy out in fixing it, but the dealer description...
...ur loyal group of secret Japanese testers have been reaching speeds of 65-68 mph on our stock four stroke engine. We had to tune the boat down so it would only do 65 at the stock settings, so we shoul...
...h call , I own both machines right now, but for racing ... I like the hx,, it takes a very strong blaster engine and hell'uva rider to beat a field of hx's, it can and has been done marc...
...In some instances, as has been posted in this group, loose throttle plate screws have been inhaled by the engine, which is obviously a 'bad thing'.
I have recently been looking for a set...
... all three classes, nov, exp, pro, on same boat? . Cyl Head never even came off.I am not questioning your engine building ability Bill O. I am challenging your big bore 951 dependabilty concept, ESPEC...
...hope someone out there has some idea as were my problem is. For starters I have a 97 Seadoo SP with a 717 engine. I'll get to the water and start her up, it runs fine. I take it out and have a bl...
...ut 50mph.
The second, gets upto about 50mph, but has low power at lower speed. Meaning slow takeoff, (engine revs high though), cant blast the throttle at about 30 mph and do a spinning slide.
...
The Content on this site is provided for general information purposes only. Your use of the Content, or any part thereof, is made solely at Your own risk and responsibility. By entering this site you declare you read and agreed to its Terms, Rules & Privacy.
Copyright © 2006 - 2010 My Jetski Buddies |
TIP: Write your question in detail [
why?
]
Latest Posts
|
