My Profile

Keep Up to Date:
Blog RSS
Blog
Forum RSS
Forum

crank

... is currently unplugged. I have replace all of these with used parts that are supposed to be good??? The crankshaft seems good and tight, no play or slop. However, on the end of the flywheel, all arou...
for sale 95 raider 1200 gp 1200 cyl,block,crank(t/w,polished) , msd total loss ign / holeshot switch ,riva 46 mm carbs/manifold , spacerplate ,boysen reeds , riva girdeled head (pg) ,billet couplers ,
...the hull, left toward the rear. Goes away when banking left or right. Not the engine. Any ideas? >2- the crankcase -oil- gets contaminated with fuel when the craft sits. Weather is warm, craft is not ...
...a 97 GP1200 superstock motor fo sale. It has been in the garage since 2000. It includes trued and welded crank,RIVA 48 mm carbs, intake spacer, K&N filters,big bore RIVA cyls.,Wiseco pistons,lightened...
SeaDoo 951 Motor from 99 GTX Limited Cases / Cylinder / Crank Countershaft all in great condition $ 800.00
...ard to start again (like still getting water from somewhere). I think the problem may have been that the crank-case bottom was still open from when I cleared it?? Is that possible? Anyway, brought i...
...atter of blocking off the injectors and injector lines ? does the oil pump also feed oil directly to the crank as some 2-stroke engines do ? anything else i need to know or may not have thought of ? m...
...ile away just stops. Was able to coast it over to the beach, popped the seat off and opened the hood. It cranks fine, so I pulled off a spark plug wire and used a key to check for spark. I usually don...
Will this warranty cover damage to crank cases due to your crank failures??? I have an SBT crankshaft that destroyed a set of Sea Doo 947 cases, pistons, and cylinder because the rod snapped like a tw
...ramp. Point is that I usually have to start this way if it has been sitting for about a week or so. Just cranks so much easier this way. Anyway, for other reasons I had enough and trailered it to brin...
Brand New stock crank built by Rad Performance New Balancer Shaft to match $495 + SH
...ear or see. Then it takes a bit of fiddling with the lanyard before it beeps to start. Pressing ignition cranks it and it starts Ok but sometimes the electrics cut out whilst cranking or just after st...
Ok, I'm helping a friend with his 96 XP and it won't crank. It hasn't been started since last Fall. The battery is up on it and I've already tried the electrical box out of my XP in his and it still w
After reading my owners manual, I see that it says to spray lube into the cylindars and crank the engine to spread the lube around - then re-insert the spark plugs. Won't this lube foul my spark plugs
Looking for a Kawasaki 650 crank. thanks
Anyone know of a good reliable place to get a 951 rebuilt crank ??
I have a 96 XP that ran last year before being fogged and put away. It now will crank but will not start because of lack of spark. Battery is now new. I get 2 beeps. Checked and cleaned all the fuse
...ogged. Everything else looks like new. Was curious if someone knew a simple precise way to make sure the crank goes back to index. I thought a scribed line across the center journal and inner half wou...
I am currently working on a 1995 SPX 5874... The starter will only crank the motor for about two seconds and then the starter gear goes back off the flywheel... My first thoughts are that its the star
...$250 plus shipping 701 62T cases off a '00 XL700. Has about 15 hours on them. $225 plus shipping 701 crankshaft out of the same '00 XL700 with about 15 hours on it. $250 plus shipping 701 cranks...
...ater and hydrolocked. Could this be caused by the feed/drain hoses on the exhaust pipe being reversed? I cranked motor with plugs out to get water out, do I still have to pull the drain plugs? 4. Wi...
...come Mr. Backfire. It has a normal limited setup, all of the electrics test good. RV timing is right on, crank seals good, enhancer is setup correctly. No matter what I do, it backfires when attemting...
...ith the new pistons and never overheated with them so I don't believe that this is an issue. When I am cranking the engine, I see no smoke from the air cleaner or exhaust indicating that the fuel I ...
98 XPL- Boat is in perfect condition. I was building it to race stock class. Looks brand new. New OEM crank, OEM cylinder, OEM pistons and all gaskets. Exhaust update done. PPG jet kit with Proks and
...ave a GP1200X 99 model that has been ported by Riva (stage 3 pump gas) and was wondering if SBT's welded cranks would be a good replacement or should I go with Riva's welded cranks. The stock cranksha...
Hi, Need to rebuild a crank from my old kawa 550, i am the manager of a machine shop and we have all the gear to do this type of work, to make any tooling and fixtures and to press the thing apart a
recently rebuilt a crank on an old sea doo 650, it was quite a mess with the front bearings so bad it had allowed tha flywheel to scrape the stator coils! crank had 1mmrunout at the front!! crank was
Hey Bill,I have a 800 fi sea-doo in the shop for a motor,sbt doesn't have any.Would you have a good crank for one or could you rebuild one if i send it to you.Top end is o.k.Crank is different on F.I
Last year I could hit 7k rpms with my 96 XP with a few mods, but I also lost my motor due to a faulty crank. Now I have a new motor...newly rebuilt, and I can not hit over 6700 rpm's? The same carb se
Is RAD still around? If so how can I contact them?
Page: 1

Copyright © 2006 - Nov 2008 My Jetski Buddies